<data.MEASUREMENTABS>

Measurement expressed in real-world (e.g., centimeters, millimeters, inches, points, picas, or pixels) or virtual units (vu). 'vu' is the default value. Unlike data.MEASUREMENTREL, which may be used to express relative measures, only positive values are allowed.
Module
MEI
Used by
These class-based attributes use data.MEASUREMENTABS
att.plica.vis/@lenEncodes the stem length.
att.stem.vis/@lenEncodes the stem length.
att.height/@heightMeasurement of the vertical dimension of an entity.
att.pages/@page.heightSpecifies the height of the page; may be expressed in real-world units or staff steps.
att.pages/@page.widthDescribes the width of the page; may be expressed in real-world units or staff steps.
att.pages/@page.topmarIndicates the amount of whitespace at the top of a page.
att.pages/@page.botmarIndicates the amount of whitespace at the bottom of a page.
att.pages/@page.leftmarIndicates the amount of whitespace at the left side of a page.
att.pages/@page.rightmarIndicates the amount of whitespace at the right side of a page.
att.stems/@stem.lenEncodes the stem length.
att.systems/@system.leftmarDescribes the amount of whitespace at the left system margin relative to page.leftmar.
att.systems/@system.rightmarDescribes the amount of whitespace at the right system margin relative to page.rightmar.
att.systems/@system.topmarDescribes the distance from page's top edge to the first system; used for first page only.
att.width/@widthMeasurement of the horizontal dimension of an entity.
att.fTrem.vis/@float.gapRecords the amount of separation between floating beams and stems.
att.hairpin.vis/@openingSpecifies the distance between the lines at the open end of a hairpin dynamic mark.
These other Data Types reference data.MEASUREMENTABS
data.LINEWIDTHDatatype of line width measurements.
Declaration
<macroSpec ident="data.MEASUREMENTABS" module="MEI" type="dt">
<desc>Measurement expressed in real-world (e.g., centimeters, millimeters, inches, points, picas, or pixels) or virtual units (vu). 'vu' is the default value. Unlike data.MEASUREMENTREL, which may be used to express relative measures, only positive values are allowed.</desc>
<content>
<rng:data type="token">
<rng:param name="pattern">
(\+)?\d+(\.\d+)?(cm|mm|in|pt|pc|px|vu)?
</rng:param>
</rng:data>
</content>
</macroSpec>